- DescriptionThe BR860 Pro is both a receiving board and an internal power unit, so you don’t need any other power gear. It takes in 90–264 Vac and turns it into reliable DC output that goes straight to LED modules. Low voltage cut-off, excessive voltage defense, current limiting, overload protection, and short circuit recovery are some of the built-in safety features that make sure the device works reliably even in tough situations.This board can handle 8bit sources up to 512×512@60Hz. It can also support 10bit or 12bit signals, however the load is a little lower depending on how the controllers are paired. It works with HDR10 and HLG formats, which means it can show more brightness and contrast. Advanced grayscale refining with up to 16bit precision and enhancement up to 22bit makes images smoother in low light and keeps fine details, especially in darker images.You can choose from several gamuts, such Rec.709, DCI-P3, and Rec.2020, and fine-tune the colors yourself. Pixel-level brightness and chroma alignment get rid of differences between modules, while seam correction gets rid of lines that are easy to see across cabinets. The BR860 Pro is a good choice for high-performance LED display configurations that need accuracy and stability since it has extra features including 90° rotation, real-time monitoring, backup redundancy, and ultra-low delay processing.Input Ports1pc AC power input (90–264 Vac range)Interface for the integrated HUB signal connectionSPI connection ports for managing module dataInterfaces for OutputDirect DC output to LED modulesHUB interface outputs for connecting panelsEthernet cascade support through receiving card topologyVideo Input OptionsSupports 8-bit video at up to 512×512@60HzIt can handle a 10-bit signal up to 512×[email protected] handle 12-bit sources up to 512×384@60HzWorks with PWM driver IC setupsWorks with both M3 and COEX controllersMain FeaturesA structure for converting power and an integrated receiving cardMulti-layer grayscale tuning for evenness at low brightnessCompatible with HDR10 and HLG22bit grayscale improvement featureChanging the RGB gamma on its ownChanging the brightness of each pixelChroma correction at the pixel levelFixing the brightness of cabinet seamsAligning the brightness of batches between modulesDefault low-delay processing, which can be as low as 1 frameCompatible with 3D displays when used with supported systems. Can rotate 90 degrees (0°, 90°, 180°, or 270°).Sleep mode that saves electricity with one clickHow to handle module flash memoryTracking temperature and voltage in real timeFinding errors in Ethernet connectivityReading back firmware and configurationBackup system with loop redundancyTwo firmware storage areas for safe updatesSpecifications for electricityVoltage input: 90–264 VacThe nominal range is 100 to 240 Vac.47–63 Hz is the frequency.Maximum input current: 2.3 AVoltage out: 4.0 VThe rated output current is 35 A.Maximum output current: 40 AEfficiency: 88% or more at 240 VacUse in standby: ≤4 WPower factor: ≥0.90 at 240 VacInrush current: 100 A at 240 VacThe environment in which you workThe temperature range for working is from -20°C to 70°C.Humidity range: 10% to 90% RH, no condensationHeight: -60 m to 5000 mPlace to StoreThe temperature for storage is -40°C to 85°C.Humidity in storage: 5% to 95% RH, no condensationAltitude for storage: less than 5000 mSpecifications for the bodySize: 49.2 cm × 16.6 cm × 2.31 cmWeight: 0.4305 kgInformation about packingEach unit is packed in a bag that doesn’t hold static electricity.There are 12 boards in each box.Size of the box: 63.5 cm × 59.5 cm × 28.3 cm
